Soudal Singapore product
A hard-setting sodium-silicate paste designed for static interior joints and openings exposed to high temperatures.
Static interior joints and openings in suitable stoves, ovens, fireplaces, flues and heating equipment.
Firecement HT cures to a rigid seal and is documented for temperatures up to 1500°C. It is designed for static, dry details rather than flexible movement joints or areas with standing water.
Use the guidance and documents for your chosen product. Contact us if the English TDS or SDS you need is not listed below.
Confirm that a hard-setting, non-elastic filler suits the detail. These products are intended for static joints and openings, not for joints that move or carry structural load.
Clean the joint or opening back to sound material and remove soot, ash, grease, dust and loose deposits.
Where the substrate is porous or very dry, dampen it lightly if the technical data sheet calls for it, so the paste does not dry out too quickly.
Fill the opening solidly through its full depth without voids, then smooth the surface before the paste begins to skin.
Allow the stated drying time, then raise the appliance to temperature gradually so the filler hardens without cracking.
Find the current technical, safety and supporting documents available for this product.
Safety data sheets are market-specific. Australian editions provide regional product information. Request the current Singapore SDS or any document not listed here from PFE Technologies.
These practical points help you achieve a reliable result.
A low-modulus neutral-cure sanitary silicone for high-humidity joints, glazing and compatible building materials. It contains a fungicidal additive and is not paintable.
A neutral-cure silicone developed for cleanrooms, laboratories, industrial kitchens, food-processing spaces and other critical interiors where the specified test evidence is required.
An elastic silicone adhesive-sealant formulated for all-glass aquarium, terrarium and glass-construction work, with joint dimensions and curing planned before filling.
Product selection help
Send the local team the materials, joint or bond dimensions, exposure, project requirements and photographs where helpful.
