Products by application
Construction and installation work may involve bonding, filling, sealing and finishing. Use a product suited to each part of the job.
Product selection
Use the products below as a starting point. Check the materials, expected load, dimensions, exposure, working time and curing time before choosing.
Temperature, humidity, surface preparation and workmanship affect the result. Test unfamiliar materials and follow the current technical and safety instructions.
Products available in Singapore
See each product page for uses, preparation guidance and current technical documents.
A fast-strength-building Fix All adhesive for jobs that need early handling strength. It is hand-tight after about 20 minutes under documented conditions and continues building strength through the stated cure period.
A high-grab Fix All construction adhesive for demanding mounting work where strong initial tack helps hold compatible materials in place.
A high-grab Fix All construction adhesive that combines at least 400 kg/m² initial tack with very fast strength build-up and a hand-tight bond after 30 minutes under documented conditions.
A hybrid-polymer adhesive and sealant supplied in 600 ml foil packs for elastic bonding and sealing on compatible construction materials.
A one-component polyurethane timber adhesive with a foaming penetration action and D4 water-resistance classification under EN 204 when used as documented.
A ready-to-use polyurethane adhesive foam for efficient bonding of compatible insulation panels, plasterboard and non-load-bearing interior blocks without mixing powder mortar.
A two-component, styrene-free anchoring resin for threaded rods, studs and reinforcing bars in suitable solid or hollow mineral substrates. Loads depend on the base material, hole geometry, installation and applicable design evidence.
A one-component, moisture-curing, self-expanding PU foam supplied with a straw applicator for filling, insulating and sealing suitable construction gaps.
A one-component, gun-applied expanding PU foam for controlled filling, insulation and sealing of suitable construction gaps.
An acetone-based aerosol for cleaning compatible PU-foam applicator guns and removing fresh, uncured PU foam. Cured foam requires mechanical removal or a dedicated cured-foam remover.
A lightweight professional applicator for threaded gun-grade PU foams, designed for controlled dispensing and maintained with the compatible fresh-foam cleaner.
Need help choosing?
Send us the materials, dimensions, exposure and any required performance standard. Photographs are helpful too.
Contact the local team
